To properly maintain and
extend the life of your RV batteries you need to have a basic
understanding of what a battery is and how it works. Batteries used
in RVs are lead acid batteries, which means they have several cells
connected in series. Each cell produces approximately 2.1 volts, so
a 12-volt battery with six cells in series produces an out put
voltage of 12.6 volts. Lead acid batteries are made of plates, lead
and lead oxide submersed in electrolyte that is 36 percent sulfuric
acid and 64 percent water. Lead acid batteries don’t make
electricity they store electricity. The size of the lead plates and
the amount of electrolyte determines the amount of charge a battery
can store.
Now it’s very important that you use the right battery for the type
of application. The battery used to start and run the engine is
referred to as a chassis battery or a starting battery. Vehicle
starters require large starting currents for short periods. Starting
batteries have a large number of thin plates to maximize the plate
area exposed to the electrolyte. This is what provides the large
amount of current in short bursts. Starting batteries are rated in
Cold Cranking Amps (CCA). CCA is the number of amps the battery can
deliver at 0 degrees F for 30 seconds and not drop below 7.2 volts.
Starting batteries should not be used for deep cycle applications.
The battery or batteries used to supply 12-volts to the RV itself
are commonly referred to as house batteries. House batteries need to
be deep cycle batteries that are designed to provide a steady amount
of current over a long period. Starting batteries and marine
batteries should not be used in this application. True deep cycle
batteries have much thicker plates and are designed to be deeply
discharged and recharged repeatedly. These batteries are rated in
Amp Hours (AH) and more recently Reserve Capacity (RC).
The amp hour rating is basically, how many amps the battery can
deliver for how many hours before the battery is discharged. Amps
times hours. In other words a battery that can deliver 5 amps for 20
hours before it is discharged would have a 100 amp hour rating 5
Amps X 20 Hours = 100Amp Hours. This same battery can deliver 20
amps for 5 hours 20 Amps X 5 Hours = 100 Amp Hours. Reserve Capacity
rating (RC) is the number of minutes at 80 degrees F that the
battery can deliver 25 amps until it drops below 10.5 volts. To
figure the amp hour rating you can multiply the RC rating by 60
percent. RC X 60 percent
The two major construction types of deep cycle batteries are flooded
lead acid and Valve Regulated Lead Acid. Flooded lead acid batteries
are the most common type and come in two styles. Serviceable with
removable caps so you can inspect and perform maintenance or the
maintenance free type. In VRLA batteries, the electrolyte is
suspended in either a gel or a fiberglass-mat. Gel cell batteries
use battery acid in the form of a gel. They are leak proof and
because of this, they work well for marine applications. There are
several disadvantages to gel cell batteries for RV applications.
Most importantly, they must be charged at a slower rate and a lower
voltage than flooded cell batteries. Any overcharging can cause
permanent damage to the cells. Absorbed Glass Mat, or AGM
Technology, uses a fibrous mat between the plates, which is 90
percent soaked in electrolyte. They are more expensive than a
standard deep cycle battery but they have some advantages. They can
be charged the same as a standard lead acid battery, they don’t
loose any water, they can’t leak, they are virtually maintenance
free and they are almost impossible to freeze.
The life expectancy of your RV batteries depends on you. How they’re
used, how well they’re maintained, how they’re discharged, how
they’re re-charged, and how they are stored, all contribute to a
batteries life span. A battery cycle is one complete discharge from
100 percent down to about 50 percent and then re-charged back to 100
percent. One important factor to battery life is how deep the
battery is cycled each time. If the battery is discharged to 50
percent everyday, it will last twice as long as it would if it is
cycled to 80 percent. Keep this in mind when you consider a
battery’s amp hour rating. The amp hour rating is really cut in half
because you don’t want to completely discharge the battery before
recharging it. The life expectancy of a battery depends on how soon
a discharged battery is recharged. The sooner it is recharged the
better.
What does all of this mean to you? That depends on how you use your
RV. If most of your camping is done where you are plugged into an
electrical source then your main concern is just to properly
maintain your deep cycle batteries. But if you really like to get
away from it all and you do some serious dry camping you’ll want the
highest amp hour capacities you can fit on your RV.
Deep cycle batteries come in all different sizes. Some are
designated by Group size, like group 24, 27 and 31. Basically, the
larger the battery the more amp hours you get. Depending on your
needs and the amount of space you have available, there are several
options when it comes to batteries.
You can use one 12-volt 24 group deep cycle battery that provides 70
to 85 AH.
You can use two 12-volt 24 group batteries wired in parallel that
provides 140 to 170 AH. Parallel wiring increases amp hours but not
voltage.
If you have the room, you can do what a lot of RVers do and switch
from the standard 12-volt batteries to two of the larger 6-volt golf
cart batteries. These pairs of 6-volt batteries need to be wired in
series to produce the required 12-volts and they will provide 180 to
220 AH. Series wiring increases voltage but not amp hours.
If this still doesn’t satisfy your requirements you can build larger
battery banks using four 6-volt batteries wired in series / parallel
that will give you 12-volts and double your AH capacity.
The two most common causes for RV battery failure are undercharging
and overcharging. Undercharging is a result of batteries being
repeatedly discharged and not fully recharged between cycles. If a
battery is not recharged the sulfate material that attaches to the
discharged portions of the plates begins to harden into crystals.
Over time, this sulfate cannot be converted back into active plate
material and the battery is ruined. This also occurs when a battery
remains discharged for an extended period of time. Sulfation is the
number one cause of battery failure. The second leading cause of
battery failure is overcharging. Overcharging batteries results in
severe water loss and plate corrosion. The good news is both of
these problems are avoidable.
Your battery must be kept from freezing
You should check the fluid in your battery
prior to every camping trip or every two weeks if you are connected
to 120 Volt power.
Never store your battery without a full
charge
|